Publicidad
Idiomas disponibles
Idiomas disponibles
remote control
Remote Pairing
The original remote that comes in the box is already paired to
the adjustable base. No further action is required. In the event
that the remote is not paired with the base, follow the steps
below.
STEP 1
Remove rear cover of the remote control by sliding it down
to expose the PAIR button. Unplug the Power Cord from
your power outlet. Wait 1 minute, then plug it back in to your
power outlet. Perform Step 2 within 10 seconds, while the
control box light is flashing.
Power Supply
Power Cord
STEP 2
Press and hold the PAIR button on the
back of the remote. The PAIR button will
illuminate and start to flash. When the
PAIR button stops flashing, the LED light
on the control box will stop flashing.
Release the PAIR button.
STEP 3
Test all remote functions. If the remote buttons do not impact
the adjustable base movements, please repeat the process
again or call customer service: U.S. 1-800-499-1965 | Canada
1-800-268-4414
Child Lock Feature
WARNING
Children and pets can be crushed or killed in moving parts
of the bed! For safety purposes, the child lock function locks
the remote control to prevent any accidental button presses
and bed movements. Engage child lock on the remote control
before leaving the room.
Activate Child Lock
Control Box LED
Deactivate Child Lock
+
Press and hold dedicated Child Lock button for
three (3) seconds.
The remote LED will flash twice to confirm
activation. When any button is pressed on
the remote while in child lock mode, the LED
illuminates for two (2) seconds or while button
is pressed.
*Child Lock feature will be deactivated when
batteries are removed.
Press and hold dedicated Child Lock button
and the Underbed Lighting button together for
three (3) seconds.
The remote LED will flash once to indicate the
remote is no longer in Child Lock. The remote
and adjustable base will work normally.
13
Publicidad
