Progress Lighting AirPro P250093 Manual De Instalación página 10

Step 7. Attach the switch housing to the
mounting plate on the motor assembly by placing
the keyhole slots from the switch housing onto the
two protruding mounting screws heads.
Figure 15
Step 8. Remove one of three switch housing
screws on the switch housing and keep for later
use, then loosen the other two.
Light kit
asscmbly
Figure 16
7.
Step 9. Connect the 2-pin connectors from the
light kit to the 2-pin connectors from the motor
assembly. Attach the light kit to switch housing
using the two key slots in the light kit. Replace the
screw previously removed on step 8. Tighten all
switch housing screws securely.
Switch housing
screw
Step 10. Insert two MAXIMUM 6W E26 LED
bulbs (included) into lamp holders. Dry your
hands before installing bulbs. Keeping the bulbs
clean is important as useful lifetime of a dirty
bulb could be shorter than a clean bulb.
Step 11. Secure the shade to switch housing by
twisting in a clockwise direction. Do not
over-tighten.
LED Bulb
Figure 17
Acrylic shade
Figure 18