KRESS KC150 Manual De Instrucciones página 9

Fitting the shoulder strap (Sold Seperately)
(See Fig. B1)
1. Adjust the length of shoulder strap to make sure
that the carabiner is about a hand's width below
the top of your hip.
2. Connect the carabiner of shoulder strap to the
Shoulder Strap Mount on the shaft of the edger.
B1
Adjust the cutting height (See Fig.B2,B3)
1. Turn off the power tool and remove the battery.
2. Loosen the wing nut. Push the wheel upwards to
increase the cut depth (a) or downward the wheel
to reduce the cut depth (a).
3. It is recommended to adjust the depth wheel so
that the edger blade just touching the ground or
breaks the surface of the soil by no more than 0.2
in. (5 mm)
4. Tighten the wing nut. Check the depth of cut
while standing in the normal working position and
correct it if necessary.
B2
2
1
B3
a
Installing & removing the battery pack
(See Fig. C1, C2)
C1
C2
1
1. Slide the battery pack into the battery
compartment until you hear a click.
2. Press the battery release button to release
battery pack from your tool.
Connecting with the backpack harness
(See Fig. C3)
The edger can be connected with an accessory
backpack harness (not supplied). Refer to the
backpack harness manual for more information.
a
2
9
EN