Bosch GWX18V-13C Instrucciones De Funcionamiento Y Seguridad página 17

Mounting and Removing
X-Lock Accessories
Only use Bosch or Bosch li-
censed
ries. Incompatible accessory mounting features
may affect clamping of accessory and may result
in personal injury and/or property damage.
Confirm proper clamping by
ensuring that top of the ac-
cessory X-Lock mounting hub surface is not
above the top of the clamping height gage. Ac-
cessories that are above the clamping height
gage may not be fixed properly and separate
from the the tool causing personal injury and/or
property damage.
Always inspect accessory
mount and accessory clamp-
ing flange before use. Do not use the tool or
accessory if the accessory mount or accessory
is damaged or deformed. Accessories that are
not clamped properly may cause personal injury
and/or property damage.
Check for presence or build-
up of foreign material on
clamping surfaces and remove before use. Un-
wanted material can cause incomplete clamping
and may cause personal injury and/or property
damage.
Never actuate X-Lock Re-
lease Lever while accessory
is moving. Make sure that the accessory has
come to a complete stop before removing the
accessory. Ejecting accessory while still spin-
ning could cause personal injury and/or proper-
ty damage.
Verify that the accessory and the X-Lock Acces-
sory Mount are not deformed and are free from
dirt. If necessary, clean the area around the two
X-Lock Clamping Tabs.
Verify that both X-Lock Clamping Tabs are open
(see Fig. 8) before fitting the X-Lock accessory.
Mounting accessory to the tool:
1. Place the accessory on the X-Lock Accessory
Mount, by aligning the shape of the Acces-
sory X-Lock Mounting Hub with the X-Lock
Accessory Mount on the grinder (Fig. 8).
2. Push the accessory into the X-Lock Acces-
sory Mount. The accessory audibly clicks as
the Clamping Tabs lock into place (Fig. 9).
160992A5K0 GWX18V-13CP 202206.indd 17
page heading Assembly
Fig. 8
X-LOCK accesso-
Fig. 9
-17-
Accessory
X-Lock
Mounting Hub
X-Lock
Accessory
Mount
6/27/22 7:17 AM