Crosscall X-COMM Manual De Instrucciones página 21

Idiomas disponibles

• Your product should be used in areas with a temperate climate.

• Do not insert or remove a USB port with wet hands as this could lead to a risk of electric

shock.

• Because your X-COMM are equipped with an internal rechargeable battery, do not expose

the product to excessive heat (sun, fire, etc.)

• Avoid using the connector to perform several actions at once, and make sure that the

battery terminals are noting touch any conductive elements, such as metal or liquid.

PROTECTING YOUR HEARING

Your X-COMM adhere to the regulations in force in terms of limiting the maximum output

volume. Listening with earphones at high volume for extended periods can cause hearing loss!

• Stop using the product or lower the volume if you feel that your ears are ringing.

• Do not listen on full volume; medical professionals advise against exposure to high noise

levels for an extended period of time.

• Use earphones wisely, as excessive sound pressure coming from earbuds or an audio

headset can cause hearing loss.

• To prevent damage to your hearing, avoid listening at high volumes for long periods of

time.

Bluetooth® headphones: Maximum output power < 20 mW

ENVIRONMENTAL PROTECTION

Please respect local regulations in terms of waste elimination when you are getting rid of

packaging, the battery or the used product. Take them to a collection point so they can be

properly recycled. Do not dispose of your used product in ordinary rubbish bins.

This symbol affixed on the product means that it is a device whose treatment as waste

is subject to Waste Electrical and Electronic Equipment (WEEE) regulations.

CLEANING AND MAINTENANCE

• Switch off your X-COMM before any cleaning or maintenance. The charger must be

unplugged from the outlet. The X-COMM and charger must be disconnected to avoid

electric shock or short circuit of the battery or charger. Close the dust caps.

• Do not clean the X-COMM or charger with chemicals (alcohol, benzene), chemical agents

or abrasive cleaners so as not to damage the parts or cause a malfunction. The device

can be cleaned with a soft, anti-static, slightly damp cloth, or with tap water following the

instructions in the Information on water resistance.