Publicidad
Idiomas disponibles
Idiomas disponibles
4. Operating the Pump
Place the Suction Strainer on a level surface IN the water. The
garden hose and pump should be OUT of the water.
Plug the pump into a properly grounded 115V GFCI outlet. The
pump should start within 30 seconds. Monitor the pump's
progress and unplug the pump before it runs dry.
NOTE: If the pump is not pumping water in 30 seconds, unplug
the pump. Check the connections on the two ends of the Suction
hose to make sure there are no air leaks. Repeat the priming
instructions.
CARE AND CLEANING
CAUTION: Always use the handle to lift the pump. Never use the power cord to lift the pump. To avoid skin burns,
unplug the pump and allow time for it to cool after periods of extended use.
Do
When the power is disconnected, inspect the pump
suction screen and remove all debris, then plug the
pump back into the grounded (GFCI) outlet.
To clean a pump clogged with debris:
Unplug the pump from electrical power.
Remove debris from the screen.
8
Do Not
Do not disassemble the motor housing. This
motor has NO repairable internal parts, and
disassembly may cause leakage or dangerous
electrical wiring issues.
Do not lift up the pump by the power cord.
For Professional Technical Support call 1-844-242-2475
Publicidad
