Descargar Imprimir esta página

FuelTech 9588 Guía De Instalación Rápida página 23

Publicidad

Idiomas disponibles

Idiomas disponibles

Configure Hall and VR sensors for frequency input
Hall: Use the red wire for signal reference and the white wire must
be disconnected. In this case, it is necessary to feed the sensor with
positive and negative
VR: Use the white wire for signal reference and the red wire for sensor
power
Configure Frequency Inputs
g -
In the "Frequency Inputs" tab it is possible to configure 4 channels
for reading speed or RPM, but each kind of input requires additional
configurations
For example: To configure the turbo RPM it is necessary to inform
the number of blades and divisions in the turbocharger so that the
reading is correct.
h -
After configuring the channels, it is necessary to save the information
in the FT Input Expander by clicking on the "Write Expander" button.
i -
After writing the channels to the FT Input Expander, it is necessary
to enable them in the CAN network, just click on the "Yes" button on
the message and the FTManager will update the map automatically.
If you click "No", the association will be manual.
23
EN

Publicidad

loading