Hella Gutmann CSC-Tool SE Manual Del Usuario página 49

Hella Gutmann
50
48
49
43 Level gauge (Use the level gauge to check whether
the laser module is placed horizontally.)
45 Laser beam output (The laser beam comes out
here. Use the laser beam to read the actual value
at the scales of the cross member and at the wheel
clamp scales of the wheel clamp module WA.)
47 Level gauge (Use the level gauge to check whether
the laser module is placed horizontally.)
49 Battery compartment cover (Insert two batteries
type AA here.)
4.3.5. Replacing Type AA Batteries
Proceed as follows to replace the batteries:
1. Switch off the laser beam with the switch.
2. Remove the battery compartment cover by tilting it from the bottom side towards the top.
3. Remove the batteries one after the other.
CSC-Tool SE
43
47 46
45
44
44 Wheel clamp scale (Read the test and measured
values here.)
46 Mounting bolt (Use it to adjust and fix the laser
module.)
48 Switch (Switch the laser on and off.)
50 Level gauge (Use the level gauge to check whether
the laser module is placed vertically.)
Product Description | 4.
49