Publicidad
Idiomas disponibles
Idiomas disponibles
L(mm)
W(mm)
590
520
Under any circumstances, make sure the Induction cooker hob is well ventilated and the air
inlet and outlet are not blocked. Ensure the Induction cooker hob is in good work state. As
shown below
Note: The safety distance between the hotplate and the cupboard above the
hotplate should be at least 760mm.
A(mm)
B(mm)
760
50 mini
Before you install the hob, make sure that
• the work surface is square and level, and no structural members interfere with space
requirements
• the work surface is made of a heat-resistant material
• if the hob is installed above an oven, the oven has a built-in cooling fan
• the installation will comply with all clearance requirements and applicable standards and
regulations
• a suitable isolating switch providing full disconnection from the mains power supply is
incorporated in the permanent wiring, mounted and positioned to comply with the local
wiring rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm air gap contact
separation in all poles (or in all active [phase] conductors if the local wiring rules allow for
this variation of the requirements)
• the isolating switch will be easily accessible to the customer with the hob installed
• you consult local building authorities and by-laws if in doubt regarding installation
• you use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall
H(mm)
D(mm)
55
51
C(mm)
D
20 mini
Air intake
A(mm)
B(mm)
560
490
+5
E
Air exit 5mm
26
X(mm)
50 mini
+5
Publicidad
