Publicidad
Idiomas disponibles
Idiomas disponibles
The terms "device" or "product" are used in the warnings and instructions to refer to
a churros maker machine.
2.1.
a)
The plug must fit the socket. Do not modify the plug in any way. Using
original plugs and matching sockets reduces the risk of electric shock.
b)
Avoid touching earthed elements such as pipes, heaters, boilers and
refrigerators. There is an increased risk of electric shock if the earthed device
is exposed to rain, comes into direct contact with a wet surface or is
operating in a damp environment. Water getting into the device increases
the risk of damage to the device and of electric shock.
c)
Do not touch the device with wet or damp hands.
d)
Use the cable only for its designated use. Never use it to carry the device or
to pull the plug out of a socket. Keep the cable away from heat sources, oil,
sharp edges or moving parts. Damaged or tangled cables increase the risk of
electric shock.
e)
If working with the device outdoors, make sure to use an extension cord
suitable for outdoor use. Using an extension cord suitable for outdoor use
reduces the risk of electric shock.
f)
If using the device in a damp environment cannot be avoided, a residual
current device (RCD) should be applied. The use of an RCD reduces the risk of
electric shock.
g)
Do not use the device if the power cord is damaged or shows obvious signs of
wear. A damaged power cord should be replaced by a qualified electrician or
the manufacturer's service centre.
h)
To avoid electric shock, do not immerse the cord, plug or device in water or
other liquids. Do not use the device on wet surfaces.
i)
ATTENTION! DANGER TO LIFE! While cleaning, never immerse the device in
water or other liquids.
j)
Do not use in very humid environments or in the direct vicinity of water
tanks.
k)
When working with the device, it is recommended to use an additional switch
protecting the electrical installation in the event of overload or leakage.
2.2.
a)
Make sure the workplace is clean and well lit. A messy or poorly lit workplace
may lead to accidents. Try to think ahead, observe what is going on and use
common sense when working with the device.
b)
If there are any doubts as to the correct operation of the device, contact the
manufacturer's support service.
Electrical safety
Safety in the workplace
Publicidad
