UFESA Riga Manual De Instrucciones página 13

ASSEMBLY
CAUTION: Ensure the product is fully assembled before plugging it into an electrical outlet.
To assemble it, refer to Fig.1: positioning first the base1 (C) then the base 2 (D) on the body,
making sure to lock with 4 screws supplied (E).
REMINDING (Fig.2): there are 2 corresponding holes at the base, the 2 pillars at the seat
need to pass through these 2 holes when assembly the base onto the fans.
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged,
if the power cord is damaged, it must be replaced by the manufacturer or a competent
qualified electrician or a person with similar qualifications, in order to avoid any risk.
Timer: This appliance has a timer for automatic switching off at the end of the time set; to
set the time turn the timer knob (A) clockwise to the position corresponding to the desired
operating time (0-120 min.); in order to operate the appliance in a continuous manner, and
to therefore exclude use of the timer, turn the knob anticlockwise to the "ON" position.
Operation: After setting the timer
- To switch the appliance on, rotate the speed switch knob (B)
- 0 = Off 1 = Speed minimum
minimum+oscillating,
To switch off the appliance, turn the speed switch knob(B) to the "0" position or turn the
timer knob(A) to the "OFF" position, and then remove the plug from the socket.
When not in use for long periods, the plug must always be removed from the socket.
MANITENANCE AND CLEANING
Warning: before carrying out regular cleaning operations, disconnect the plug from the
mains socket.
To clean the appliance, use a soft, slightly damp cloth; do not use abrasive or corrosive
products.
Do not immerse any part of the fan in water or any other liquid: if this should happen, un-
der no circumstances should hands be put into the liquid; first disconnect the plug from
the mains socket. Then dry the appliance carefully and check that all the electrical parts
are dry: if in doubt, check with professional qualified technician.
It is essential that the motor ventilation holes are free of dust and fibres.
In case of long periods of non-use store the fan, protecting it from dust and moisture; we
recom- mend using the original packaging.
PRODUCT DISPOSAL
This product complies with European Directive 2012/19/EU on electrical and elec-
tronic devices, known as WEEE (Waste Electrical and Electronic Equipment), pro-
vides the legal framework applicable in the European Union for the disposal and
reuse of waste electronic and electrical devices. Do not dispose of this product in
the bin, instead going to the electrical and electronic waste collection centre clo-
sest to your home. We hope that you will be satisfied with this product.
2 = Speed medium
= Speed medium+ oscillating
3 = Speed maximum
= Speed maximum+ oscillating
= Speed
13