Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
7. Using a 5/16" drill bit, drill all 12 of the
marked holes on your wall for the pegboard
wall anchors. After holes are drilled, lightly
tap the wall anchors flush to the wall.
Hardware Used
CC
Wall Anchor
8. Insert a screw and wall spacer in the holes
on both pegboards. Set the depth and
angle of the screw.
Hardware Used
AA
Wall Spacer
BB
2" Screw
9. Carefully set the first pegboard in the lower
K-Rail track and bend the board at the top
into the upper K-Rail track. Now align each
screw into the wall anchor and get them all
started by hand with a few turns, then go
back and screw them in.
Tip: Do not tighten them all the way until you
have the 2nd pegboard up in the same
fashion. This will allow a little bit of wiggle
room as you are tightening the screws to
make sure the seam down the middle of
the pegboards is tight.
Hardware Used
AA
Wall Spacer
BB
2" Screw
x 6
x 6
x 6
x 18
x 18
11
8
8
Publicidad
