Kobalt KB-PPK18 Manual De Instrucciones página 6

ASSEMBLY INSTRUCTIONS
1. Position the first pegboard in your desired
location and make sure it is level.
For installation with optional K-Rail go to page 5
K-rails sold separately
2. While holding the pegboard in place, mark a
line on your wall down the right side of the
pegboard, then mark the center of the
pegboard holes on your wall. Tip: You can
omit drawing the line down the right side of the
pegboard and install temporary screws into the
1st pegboard to hold it in position so you can
align the 2nd pegboard up to it and mark the holes.
Hardware Used
BB
2" Screw (Optional)
1
2
x 2
6