Kobalt KB-PPK18 Manual De Instrucciones página 7

ASSEMBLY INSTRUCTIONS
3. If you didn't follow the tip in step 2, line up
the next pegboard on the right side of the
line you marked on your wall in Step 2
and mark the holes. Make sure to use the
left side of your line for a tight fit between
the pegboards.
4. Using a 5/16" drill bit, drill all 18 of the
marked holes on your wall. Make sure to
keep your drill straight and steady for a tight
wall anchor fitting. After your holes are
drilled, lightly tap the wall anchors all the
way in.
Hardware Used
CC
Wall Anchor
5. Insert a screw and wall spacer into each
hole on both pegboards.
Hardware Used
AA
Wall Spacer
BB
2" Screw
x 18
x 18
x 18
7
5