Kobalt KB-PPK18 Manual De Instrucciones página 8

ASSEMBLY INSTRUCTIONS
6. Bring the pegboard up to your wall and align
each screw to the wall anchor. Get them all
started by hand with a few turns, then go
back and screw them in. Tip: Do not tighten
them all the way until you have the 2nd
pegboard up in the same fashion. This will
allow a little bit of wiggle room as you are
tightening the screws to make sure the
seam down the middle of the pegboards is tight.
Hardware Used
AA Wall Spacer
BB
2" Screw
7. Install hooks in desired locations using the
hook screws.
1
x 18
x 18
Screw locks
hook in place
2
Tab locks into
pegboard
7
8