Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
9. Carefully set the first pegboard in the lower
K-Rail track and bend the board at the top
into the upper K-Rail track. Now align each
screw into the wall anchor and get them all
started by hand with a few turns, then go
back and screw them in.
Tip: Do not tighten them all the way until you
have the 2nd pegboard up in the same
fashion. This will allow a little bit of wiggle
room as you are tightening the screws to
make sure the seam down the middle of
the pegboards is tight.
Hardware Used
AA
Wall Spacer
BB
2" Screw
10. Install peghooks in desired locations using
the hook screws. K-rail accessories
(not included) can be added to either the
upper/lower K-rail as desired.
Hardware Used
DD
1/4" Hook Screw
1
x 18
x 18
x 21
Screw locks
hook in place
2
Tab locks into
pegboard
10
12
Printed in China
Publicidad
