Whirlpool WA8059Q Manual De Instrucciones página 33

6.- Smart mode "SMART"
Press the SMART button, the unit will enter SMART mode
directly regardless of whether the unit is on or off.
In this mode, temperature and fan speed are automatically set
based on the temperature of the room.
The operating mode and temperature are determined by the
internal temperature.
SMART control for models with heat pump only
Internal Operating
temperature mode
21°C or less HEATING
21°C – 23°C FAN ONLY
23°C – 26°C DRY
Above 26°C COOLING
SMART control for models with cooling pump only
Internal Operating mode
temperature
23°C or less
23°C – 26°C
Above 26°C
The SMART button does not work in Turbo mode.
Note: The temperature, air flow and direction are automatically
controlled in SMART mode. However, a decrease or increase of
7 °C can be set with the remote control if you do not feel
comfortable.
What can be done in SMART mode
What do you feel
Not comfortable because of the volume of
air flow
Not comfortable due to the direction
of the air flow
OPERATING INSTRUCTIONS
Temperature target
22°C
The temperature in the
room decreases 2°C
after 3 minutes of
operation
26°C
Temperature
target
FAN ONLY 22°C
DRY The
temperature
in the room
decreases
2°C after 3
minutes of
operation
COOLING 26°C
Button
FAN
SWING
Setting up procedure
The speed of the indoor fan alternates between High, Medium
and Low each time the button is pressed.
Press once, the vertical adjustment grid changes to change the
direction of the vertical air flow. Press again, the grid that
distributes the air stops. For the direction of the horizontal air
flow, please see the chapter "Control of air flow direction".
Turbo
Smart
Display Off
10