Whirlpool WA8059Q Manual De Instrucciones página 37

Cleaning the front panel of the indoor unit
1. Unplug the unit from power supply
First Turn off the air conditioner before removing the power cord from power supply.
2. Remove the front panel
Open the front panel as shown with the arrows (Fig. A).
Pull the slots on the side of the front panel, pull hard to move the front panel (Fig. B).
3. Clean the front panel
Wipe with a soft, dry cloth. Use warm water (below 40 °C) to clean the appliance if it
is very dirty. Allow to dry after cleaning.
4. Close the front panel again.
Close the front panel by pushing down.
Note:
Do not use substances such as gasoline or dust to clean the appliance.
•
• Do not splash water in the indoor unit, it's dangerous! It can cause an
electric shock.
Cleaning the air filter
It is necessary to clean the air filter after using it for approximately 720 hours. Clean
the air filter every two weeks if the air conditioner is operating in an extremely dusty
environment.
1. Unplug from the power supply
First turn off the appliance before disconnecting it from the electrical power.
2. Remove the air filter (Fig. C)
1. Open the front panel.
2.Press the filter handle gently.
3. Slide the filter out.
3. Cleaning the air filter (Fig. D)
If the filter is very dirty, clean it with a solution of warm water and neutral detergent.
After cleaning let it dry.
4. Reinstall the filter.
Important:
Clean the air filter every two weeks if the air conditioner is used in a dusty environment.
MAINTENANCE
WARNING
Electrical shock hazard
Unplug the power cord or disconnect power from the
switch before performing any maintenance service or
cleaning on the unit.
Do not spill any liquids over the air conditioner unit.
Failure to follow these instructions can result in death,
fire or electrical shock.
Front panel Maintenance
14