Publicidad
Idiomas disponibles
Idiomas disponibles
4.5
Checking the condition of the air filter
1.
Unlock the air filter cover (D1) and remove it.
2.
Remove the filter element (D2), tap it on a hard, flat surface then check carefully that it is in good condition: it must not be
clogged, blocked, torn or have holes in it.
3.
Replace the filter element if necessary.
4.
Refit the air filter cover and lock it.
4.6
Starting the generating set
Once the daily checks have been performed, and having read the instructions and safety regulations carefully:
1.
Open the fuel tap (A4-C1).
2.
Turn the key (A3) to the "ON" position: all the indicator lights on the APM202 (A10) light up briefly.
3.
Press the "START" button once: after a few seconds, the unit starts.
The APM202 automatically performs 3 starting attempts. If the unit does not start, repeat the procedure once only.
4.7
Using the electricity supplied
1.
Allow the unit speed to stabilise and the temperature to rise (approx. 3 to 5 min.).
2.
If the choke was used, return it gradually to its original position.
3.
Connect the equipment to be used to the electrical sockets (A12) on the unit.
4.
Use the working hours counter (A13) to monitor the running time of the unit.
For France only: Our units are fitted with European (Schuko type) sockets where the earthing contact is made using side tabs. In
exceptional cases where your equipment requires the use of earthing pins, we supply* a 16 A pin adaptor (compliant with NF C 61-
314).
*
Contact our sales department on 0 825 004 002 (calls charged at €0.15 per min inc. tax) and provide proof of purchase.
After use, always disconnect the adaptor and store it carefully, away from sources of humidity. Always
ensure that the socket cover on the unit is closed: risk of damage (loss of seal).
IMPORTANT
Schuko type
generating set
socket, with cover.
4.8
Switching the generating set off
1.
Disconnect the equipment used, taking care to close the cover for the unit's sockets (A12).
2.
Allow the unit to run idle for 1 or 2 minutes.
3.
Turn the key (A3) to the "OFF" position: the unit will shut down.
4.
Close the fuel tap (A4-C1).
Always make sure that the unit is correctly ventilated.
Even when turned off, the unit continues to give off heat.
IMPORTANT
5 Generating set maintenance
As a safety measure, maintenance should be performed on the generating set regularly and carefully by people who have the
necessary experience and are equipped with suitable tools, in respect of current regulations. The maintenance operations to be
carried out are detailed in the maintenance table. The interval for this is supplied as a guide and for generating sets operating with
fuel and oil which conform to the specifications given in this manual. The maintenance intervals can be shortened depending on the
generating set's operating conditions and requirements. It is important to note that the warranty shall not be valid if generating set
maintenance has not be performed correctly.
5.1
Reminder of use
Ensuring maintenance is performed regularly and correctly will guarantee safety and performance. The oil, filter elements and,
where present, the spark plug, are consumables which must be in good condition for the unit to operate correctly.
Replace them regularly as often as is needed (the reference for ready-to-use maintenance kits is given in the table of
technical specifications where applicable). The warranty becomes void in the event of failure to respect the maintenance
recommendations. For any questions about a special operation, please contact your nearest agent who will advise and help you.
French plug
NF C 61-314
Use the adaptor
17/250
Mixed plug
No need to use
adaptor
Publicidad
