Jocel NSBK-200WS2 Manual De Instrucciones página 24

4.9 button: it can only by operated under the
timing (OFF) selection (switching).
5. RESET weekly timing time setting clear button.
6. The backlight display only shows the time and
the standby button flickers interval 3 seconds. Press any button to light the display screen.
THE INSTALL METHODS ON THE WALL
1. Drill two holes on the flat wall 180cm away from ground, the distance between the two holes is 46cm.
Stuff the stopper or expanding bolt and screw the wood bolt. Instruction as below:
2. Ring the wood bolt into the key hole of the wall mounted warmer and pull down to make the wood bolt
embedded into the line slot of the key hole.
ATTENTION AND MAINTAINS
1. When using the warmer, the ammeter should be endured the power marked on the mark of appliance.
The outlet must have reliable ground connection and can endure 10A or above current.
Fig. 3
condition. Press "
standby buttons after 60 seconds. At the same time,
Fig. 5
" button is timing (ON) or
Fig. 4
24