Publicidad
Idiomas disponibles
Idiomas disponibles
•Do not use the jig saw to cut asbestos or materials containing asbestos. Do not
FR
or leave until it has stopped completely.
ES
•Be careful when working on walls. Damage to power supply lines, gas or water
pipes can lead to dangerous situations. Use appropriate detectors to establish
PT
whether there are concealed wires or pipes in the working area.
•Always check that the mains voltage corresponds to the voltage on the device's
IT
rating plate.
•Secure the work piece. The work piece is only secure if it is held by work-hold-
EL
ing devices or in a vice.
•Use of extension cables. Only use extension cables which are designed for the
machine's power. The minimum conductor cross section must be 1.5 mm2.
PL
When using cable reels the cable must always be completely unrolled. • Always
remove the mains plug before replacing saw blades.
UA
•Caution: saw blades can get very hot.
•Saw blades must be kept sharp and in good condition. Replace partially frac-
RO
tured and broken saw blades immediately.
•Work calmly and evenly with the jig saw. You will thus avoid accidents and the
saw blades and the jig saw will last longer.
EN
4.Technical Spe
Model
Rated voltage /frequency
Rated power
Stroke per minute
Max. cutting thickness in steel
Max. cutting thickness in wood
Work model-vibration emission value a(m/s
tion
ZY8504
220-240 V~50 Hz
400 W
3000/min
6 mm
5 mm
a
h,B = 1
m/s
2
2
)
a
h,M = 1
m/s
2
2
K = 1.5 m/s
116
Vibration information
The declared vibration total value has been measured in accordance with a
standard test method and may be used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment
of exposure.
4.Technical Speci
that the vibration emission during actual use of the
WARNING!
pending on the ways in which the tool is used; and of the need to identi-
fy safety measures to protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking account of all parts of the
is running idle in addition to the trigger time).
5.Functional description
Before using the jig saw, familiarize yourself with all the operating features and
safety requirements.
117
L
= 86 dB(A)
PA
K
= 5 dB(A)
PA
L
= 97 dB(A)
WA
K
= 5 dB(A)
wa
tion
-
FR
ES
PT
IT
EL
PL
UA
RO
EN
Publicidad
