Publicidad
Idiomas disponibles
Idiomas disponibles
1.Power cable
FR
2.Locking button
ES
4.Inspection guard
5.Saw blade
6.Guide roller
PT
7.Adjustable base
8.Hex Key
IT
9.Dust extractor socket
EL
PL
UA
6. Operation
Insert mains plug into an outlet, always check that the power sup-
RO
ply corresponds to the voltage on the rating plate (Rated voltage:
220V-240V, 50HZ).
EN
1)Changing the saw blade
Releasing the saw blade. Turn the screws anticlockwise Insert the saw blade in
the groove up to the stop and tighten the two screws of the retention clip.
Make sure the saw blade sits properly in the
Important!
slot of the roller and groove.
2)Switching ON/OF
3)Adjusting the base
Undo the 2 screws to set the base to an angle up to 45° on the right or left side.
2
1
3
8
4
7
5
6
118
4)Sawing tips
Cutting veneered chipboard:
Position the base on the uncovered area Advance the saw with little force.
tion.
5)Dust extraction
9
The jigsaw is equipped with a dust extractor socket. You can connect your vacu-
um cleaner to the socket at the rear of the jigsaw. If you require a special adapt-
er, please contact the manufacturer of your vacuum cleaner.
7.Maintenance
WARNING!
plastic parts. They contain chemicals that can damage, weaken or destroy
the housing, thus compromising the integrity of the double insulation.
a)Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tight-
ened. Should any of the screws be loose, tighten them immediately. Failure to
do so could result in serious injuries.
b)Maintenance of the motor
The motor unit winding is the very "heart" of the power tool. Exercise due care
to ensure the winding does not become damaged and/or wet with oil or water.
c) Inspection the carbon brushes
The motor employs carbon brushes which are consumable parts. Since an exces-
sively worn carbon brush could result in motor trouble, replace the carbon brush
with an identical part when it becomes worn to or near the limit. In addition,
always keep carbon brushes clean and ensure that they slide freely with in the
Do not all
uids, gasoline, petroleum-based
products penetrating oils, etc. Come in contact with
119
FR
ES
-
PT
IT
EL
PL
UA
RO
EN
Publicidad
