Publicidad
Idiomas disponibles
Idiomas disponibles
Audio Settings
Audio Settings
1
Display the <Audio> screen.
On the source/option selection screen (page 10):
Then, on the <Setup> screen, touch as follows:
[Audio] (1) [Enter] for the item you adjust (2).
Setup
Equalizer
Audio
Enter
Display
Sound Effect
Enter
Fader / Balance
Input
Enter
Speaker / X'over
System
Enter
Time Alignment
Enter
2
Adjust the item.
The <Audio> settings are not adjustable;
• When the unit is in standby (STANDBY).
• When the Bluetooth phone is used (making or
receiving a call, during a call, or while voice dialling).
• When Apple CarPlay or Android Auto is used for
phone calling.
<Equalizer>
The following adjustments are memorized for each
source until you adjust the sound again.
Selecting a preset sound mode
Select a preset sound mode on the <Equalizer>
screen (1).
• Pops/Easy/Top40/Jazz/Powerful/Rock/Flat
(Initial)/Bass Boost/User1/User2/User3/User4
Equalizer
SRC Name
Preset
Flat
[dB]
+9
+7
+5
+3
0
-3
-5
-7
-9
62.5
100
160
250
400
630
1k
1.6k
2.5k
4k
6.3k
10k
Bass EXT
ON
OFF
EQ INIT
SW Level
0
ALL SRC
<SW Level>
Adjusts the subwoofer level (2).
• Not adjustable when <None> is selected for
subwoofer on the <Speaker Select> screen.
• –50 to +10 (Initial: 0)
To apply the adjusted equalizer to all playback sources,
touch [ALL SRC], and then touch [OK] to confirm.
<Sound Effect>
Adjust the sound effect.
<Loudness>
Adjusts loudness.
• OFF (Initial)/Low/High
<Bass Boost>
Selects the bass boost level.
• OFF (Initial)/Level 1/Level 2/Level 3
<Drive Equalizer>
Reduces the driving noise by raising the bandwidth.
• OFF (Initial)/ON
<Space Enhancer>
Virtually enhances the sound space using the Digital
Signal Processor (DSP) system (except for analog
broadcast stations). Select the enhance level.
• OFF (Initial)/Small/Medium/Large
<Supreme>
Compensates the sound lost while audio compression
process (except for analog broadcast stations).
• OFF/ON (Initial)
<Realizer>
16k [Hz]
Virtually makes the sound more realistic using the
Digital Signal Processor (DSP) system. Select the sound
level.
• OFF (Initial)/Level 1/Level 2/Level 3
<Stage EQ>
Moves the center of the sound to the lower or higher
point. Select the height.
• OFF (Initial)/Low/Middle/High
<Fader/Balance>
J
Touch [
]/[
<Fader>
When <X'over Network> is set to [2 way], you can
adjust the front and rear speaker output balance.
• F15 to R15 (Initial: 0)
<Balance>
Adjusts the left and right speaker output balance.
• L15 to R15 (Initial: 0)
To clear the adjustment: Touch [Center].
K
H
I
]/[
]/[
] or drag the
mark to adjust.
ENGLISH
25
Publicidad
