Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE & ADJUSTMENT GUIDE
4
33
23
2
CLEANING
The recumbent bike can be cleaned with a soft, clean, damp cloth. Do not use abrasives or solvents
on plastic parts. Please wipe your perspiration off the recumbent bike after each use. Be careful not
get excessive moisture on the computer display panel as this might cause electrical hazards or
electronics to fail.
Please keep the recumbent bike, especially the computer, out of direct sunlight to prevent screen
damage.
Please inspect all assembly bolts and pedals on the recumbent bike for proper tightness every week.
STORAGE
Store the recumbent bike in a clean and dry environment, away from children.
ADJUSTING THE SEAT
Turn the Adjustment Knob (No. 33) counter-clockwise to
release Seat Post (No. 4) and then slide the Seat Post (No.
4) forward or backward to the desired position. Secure the Seat
Post (No. 4) in place by turning the Adjustment Knob (No.
33) clockwise until tightened.
33
MOVING THE RECUMBENT BIKE
To move the recumbent bike, hold the Rear Stabilizer (No. 68)
and tilt the recumbent bike until the End Caps (No. 31) located
on the front stabilizer touch the ground. With the End Caps
(No. 31) on the ground, you can transport the recumbent bike
to the desired location with ease.
ADJUSTING THE BALANCE
To achieve a smooth and comfortable ride, you must ensure
that the recumbent bike is stabled and secured. If you notice
the recumbent bike is unbalanced during use, adjust the End
Caps (No. 25) located on the Rear Stabilizer (No. 68) until the
recumbent bike becomes levelled with the floor surface.
ADJUSTING THE TENSION
Adjust the tension by rotating the Tension Control Knob (No.
23) clockwise to increase the level of resistance. Rotate the
Tension Control Knob (No. 23) counter-clockwise to
decrease the level of resistance.
Tension levels are set at Level 1 being the lowest and Level 8
being the highest.
10
Publicidad
