Publicidad
Idiomas disponibles
Idiomas disponibles
PERGOLA 60 io RGS
PERGOLA 50 io RGS
To activate/deactivate the function
1] Perform a complete up and down cycle, all the way to the motorised
product's upper and lower end limits.
2] Press the Down button to place the motorised product at the lower end limit.
3] Press the my and Up buttons simultaneously until the motorised product
moves up and down briefly.
ð If the function was deactivated, it is now activated.
ð If the function was activated, it is now deactivated.
To use this function
1] Press the Down button: the motorised product lowers to the lower end limit.
2] Lock the catches manually.
3] Press the my button: the motorised product lowers then raises to draw the
fabric taut.
To raise the motorised product at the upper end limit
1] Press the Down button: the motorised product lowers to the lower end limit.
2] Unlock the catches manually.
3] Press the Up button: the motorised product raises to the upper end limit.
4.5."Back impulse" function
NOTICE
Refer to the Somfy professional application to activate this function.
NOTICE
• This function allows the fabric to be stretched after each opening movement of the motorised product. It can be
adjusted up to ½ turn of the tube of the motorised product.
• This function can only be activated once the end-limit setting of the drive is completed.
4.6."Closing force" function on end products
This function enables the closing force of the end product to be increased or decreased to 3 levels (high/medium/low).
The drive is factory set at the medium level.
This function can only be accessed via Somfy professional application.
4.7.Operation with sensors
NOTICE
It is not possible to pair a sensor without having an io control point.
Refer to the corresponding instructions.
©
Copyright
2022 SOMFY ACTIVITES SA. All rights reserved.
1]
2]
3]
1]
2]
3]
1]
2]
3]
EN
15
Publicidad
