SOMFY PERGOLA 50 io RGS Manual De Instrucciones página 11

PERGOLA 60 io RGS PERGOLA 50 io RGS
3.5.2.Programming an io-homecontrol point that has not been pre-
programmed
1] Switch off the power supply (the pre-programmed control point is deleted).
2] Switch the mains power supply back on. The motorised product briefly moves
up and down.
3] Simultaneously press the Up and Down button of the control point to be
programmed until the motorised product briefly moves up and down.
4] Briefly press the PROG button of this control point: the motorised product
briefly moves up and down; the control point is programmed.
3.6.Tips and advice on installation
3.6.1.Questions about the product?
Observations
The motorised product does not
operate.
The driven product stops too soon.
3.6.2.Re-setting the end limits
NOTICE
• The following steps apply only for end limits that are set manually.
• An io control point must be definitively programmed to carry out these steps.
©
Copyright 2022 SOMFY ACTIVITES SA. All rights reserved.
Possible causes
The wiring is incorrect.
The drive's overheating protection has
tripped.
The control point battery is low.
The control point is not compatible.
The control point used has not been
programmed into the drive.
The ring is not correctly installed.
The end limits are incorrectly
programmed.
1]
2]
ON ON
3] 4]
0.5 s
Solutions
Check the wiring and modify it if
necessary, referring to Wiring [} 5] .
Wait for the drive to cool down
Check the battery and replace it as
required.
Check the compatibility and replace the
control point if necessary.
Use a programmed control point or
program this control point, referring to
Programming the first local io-
homecontrol point [} 10] .
Secure the ring correctly.
Reset the end limits.
EN
OFF
11