Publicidad
Idiomas disponibles
Idiomas disponibles
▶ Replace loose connectors and damaged leads before use. All leads and lines must be securely
connected, undamaged and insulated.
▶ Do not wrap leads and lines round your body or parts of the body.
▶ Disconnect products not in use from the AC supply.
▶ Disconnect the AC supply and the connection between welding machine and charger before beginning
cleaning and maintenance work or if charging is interrupted.
▶ Do not expose the product to rain or snow. Avoid ingress of moisture.
▶ To reduce the risk of damage to connectors and leads, when disconnecting always pull only the
connector, never the lead.
▶ Do not operate the charger with a damaged lead or connector. Immediately replace the damaged lead
or connector.
▶ Do not operate the charger if it has received a hard knock, was dropped or has been damaged in any
other way.
▶ Do not disassemble the charger. Incorrect re-assembly can lead to a fire risk and electric shock. If
maintenance or repair becomes necessary, consult Hilti Service.
▶ Operate products with a protective earth conductor only when connected to a power supply system with
protective earth and a power outlet with protective earth contact.
Battery charger use and care
▶ To avoid injuries, use the charger only to charge the battery of the Hilti FX 3-A welding machine.
▶ To avoid injuries, operate the product only with all safety devices in full working order. Before you switch
the product on, make sure that no-one is going to be put at risk.
▶ Use the product and accessories only when they are in perfect working order.
▶ Never tamper with or modify the product or accessories in any way.
▶ The use of accessories not recommended or sold by Hilti can lead to a fire hazard, an electric shock or
injury to persons.
▶ The location at which the charger is used should be clean, cool, dry and protected from frost.
▶ The charger must be able to give off heat while charging is in progress. Accordingly, remove the charger
from the toolbox. Do not operate the charger inside a closed container.
▶ Maintain the product carefully. Check to ensure that no parts are broken or damaged in such a way that
the appliance may no longer function correctly. If parts are damaged, have the parts repaired before
using the appliance.
▶ Misuse can result in liquid escaping from the battery. Avoid contact with this liquid. If contact accidentally
occurs, rinse with water. Seek medical attention if the liquid comes into contact with the eyes. Liquid
escaping from the battery can cause skin irritation or burns.
▶ Do not charge or continue to use a damaged welding machine (e.g. with cracks, broken parts, bent or
pushed-in and/or pulled-out contacts).
Service
▶ Have your product repaired only by qualified, skilled personnel, using only genuine Hilti spare parts. The
safety of the product can thus be maintained.
3
Description
3.1
Product overview
*2302421*
1
2302421
Supply cord
@
Charging cable socket
;
Operating panel
=
Fault indicator (red)
%
Power-in indicator (green)
&
Quick charge button
(
Fully-charged indicator (green)
)
Quick charge indicator (green)
+
Charge indicator (green)
§
Charging cord
/
English
9
Publicidad
