Descargar Imprimir esta página

Linksys AC1900 Manual Del Usuario página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

If it blink s amber
repeating step 3 or try brow
4.
Extend your 5 GHz network.
You may skip this step if your router does not have a 5 GHz network
extend that network.
a.
Press the WPS
complete step 4b.
b. Press the WPS button on your range extender again.
The WPS button will light up and the indicator LED on the front of your range
extender will start to blink green.
Watc h the indicator LED on the front of your range extender to verify whether the
connection was successful.
If it turns solid green
If it starts to blink amber
failed. You may try
5.
Move your range extender
Unplug your range extender and plug it back in
without Wi -Fi. Using your mobile device or laptop, be sure you have at least two bars
(around 50%)
of your router's Wi -Fi signal at that location. If you don't have two bars,
move the range extender closer to the router.
6.
Check indicator LED for connection quality.
It can take up to a minute for the ranger extender to boot up after moving it. During t
period you will see the blinking green LED once again.
o
Solid green
, the connection failed. You may try again by
ser -based setup on page
button on the side of your router again.
, the connection was successful.
again by repeating step 4.
to an ideal spot.
Ready to use.
9
.
Within the next two minutes
before it turns solid green, the connection
midway between your router and the area
or if you don't want to
his
8

Publicidad

loading

Este manual también es adecuado para:

Re7000