Bosch ISP-EMIL-120 Manual De Instalación página 21

Expansion modules
1 Safety
Notice!
The installation can only be performed by official personnel.
Warning!
Current-carrying components and isolated cable
!
Injuries due to electric shock are possible.
Switch off all electricity before connecting.
Caution!
Electrostatic-sensitive components
!
Damages of the electronic components due to electrostatic discharge are possible.
Attach grounding wrist strap or take other suitable measures.
2 Short information
This manual describes the installation and wiring of the following EMIL Expansion Modules
LSN:
–
–
–
The expansion module can be used to connect 6-detector zones (conventional detectors or
monitoring contact inputs), for control purposes (4 control outputs), or for connecting arming
devices (for example NBS 10) with system components to the local security network (LSN).
The expansion module has been developed for connection to LSN control panels and provides
the extended functionality of LSN improved technology. The LSN mode "classic" can be
selected via the integrated DIP switch (default setting), enabling the connection of all classic
LSN universal security systems.
A maximum of 2 IMS-RM relay modules can optionally be installed in the expansion module
housing (2 relays per relay module, 2 switch contacts per relay), if the switched control
elements cannot be directly controlled from the expansion module due to the high current
requirement, or to enable zero-potential switching.
A wall tamper contact can be installed, if required (optional). In case of an EN 50131-3 Grade
3 compliant installation, the wall tamper is mandatory.
3 Installation
1.
2.
3.
4.
4 Address setting
1.
2.
Bosch Sicherheitssysteme GmbH
ISP-EMIL-120
ISP-PCBA-EMIL
ISP-EMIL-3RDP
Prepare the installation, refer to graphic 1 in chapter Graphics, page 4.
Open the wiring entry points, refer to graphic 2 in chapter Graphics, page 4.
Mount the lower part of the device and the screw for the wall tamper contact (optional)
to the wall, refer to graphic 3 in chapter Graphics, page 4.
Mount the connection terminals, the relay module (optional), and the wall tamper contact
(optional), refer to graphic 4 in chapter Graphics, page 4.
To set the addresses of the expansion module, use a suitable pointed implement to set
the 8 DIP switches on the connector board.
For the DIP switch settings (1 = on, 0 = off) for all permissible addresses, refer to graphic
5, graphic 5.1, and graphic 5.2 in chapter Graphics, page 4.
Installation Manual
Safety | en 21
2017.09 | 04 | F.01U.076.548