Human Touch Circa ZG Manual De Uso Y Cuidado página 4

get ready
UNPACK THE BOX
Chair Body
Head Pillow
PLACE THE CHAIR
1. Consider the following when choosing a chair location:
• Place the chair on a flat, level, carpeted surface to prevent damage to the floor and minimize chair
motor noise.
• Choose a location that is not exposed to direct sunlight for extended periods, to prevent upholstery fading.
• Allow at least a 25-inch clearance behind the chair and a 15-inch clearance in front of it (Fig.1).
25"
Clearance
humantouch.com
Chair base Connecting
Shaft
Power Supply Power Cable
15"
Clearance
Fig.1
4
Your Human Touch Circa ZG Chair
assembly. Just attach the chair body to the base, connect
the power supply, place the head pillow, and you're done!
ASSEMBLE THE CHAIR
1. To avoid scratching the chair, choose a carpeted location or place a clean blanket on the floor for assembly (Fig.3).
2. Place the front of the chair body on the floor, then tip it forward until the headrest reaches the floor (Fig.3).
3. Install the large end of the connecting shaft into the receptacle on the chair base, aligning the arrows (Fig.2).
Connecting
Shaft
Chair base
Fig.2
4. Slide the small end of the connecting shaft into the receptacle on the bottom of the chair body (Fig.3).
Fig.3
requires some simple
Aligning
the arrows
5 5