Gymrex GR-MG76 Manual De Instrucciones página 34

Important: Two people are required to work together during assembly. One person
holds the computer unit while the other person tightens the screws using the Allen
key (S1) included in the kit.
First, connect the signal cable from the computer assembly to the signal cable from
the standing frame. Next, secure the computer unit to the stand frame using four
M8x16mm Allen head screws (S3), two spring washers (S5), and two flat washers
(S6) on each side. Tighten the screws using the supplied Allen key (S1).
A. Wiring connectors to be connected
Step 3 Installing the Caps
Attach the overlays (S7) to the standing frame using four M5x10mm Phillips head
screws (S4) on both sides, tightening the screws using the included Allen key (S1).