Publicidad
Idiomas disponibles
Idiomas disponibles
Preliminary Instructions (cont.)
SASH
19" MIN.
1/2" MIN.
Storm Window Frame
or Other Obstruction
Hardware (Packed with the unit)
7/16" Locking screw and
Flat washer for accordion panels
3/4" (or 1/2") Long
Hex-head Screw
Safety Lock
1/2" Long screw
and Locknut
3/4" Long Flathead Bolt
and Locknut
Sill Angle Bracket
Long hex-head locking screw
for top rail, side retainer
5/16" Length
Cabinet Foam Insert
Window sash seal foam
Locking screw #10 X 1/4" panhead
Phillips screws (for Vinyl-Clad window)
Weather stripping
(10" *3/4" *1/12" )
Safety Lock
(for Vinyl-Clad window)
Accordion Panel Insulation
Lock Frame (For Wooden
windows) (on some models)
3/4" Long Screw (on some models)
User Manual
1. Check window opening size - the mounting parts furnished with
Fig. D
this air conditioner are made to install in a wooden sill double-
hung window. The standard parts are for window dimensions
listed above. Open sash to a minimum of 19" (483 mm). See Fig. D.
2. Check condition of window - all wood parts of window must be
in good shape and able to fi rmly hold the needed screws. If not,
make repairs before installing unit.
3. Check for anything that could block airfl ow - check the area outside
of window for things such as shrubs, trees, or awnings. Inside, be
sure furniture, drapes, or blinds will not stop proper airfl ow.
4. Check the available electrical service - Power supply must be the
same as that shown on the unit serial nameplate. Power cord is
48 in long. The outlet should be within reach of the power cord.
5. Carefully unpack air conditioner - Remove all packing material.
Protect fl oor or carpet from damage. Two people should be used
to move and install unit.
2 ea.
7
1
4 ea.
2 ea.
2
10
2
1
2
5
2
2
2
2
NOTICE
Accordion Panel Insulation and weather stripping
is for ENERGY STAR models only.
Tools You Will Need
Tools You May Use
Ruler or tape measure
Phillips
Screwdriver
Level
Flathead
Screwdriver
Pencil
Scissors or knife
Page 13
Publicidad
