Publicidad
Idiomas disponibles
Idiomas disponibles
EN
the speed decreases abruptly, reduce
the pressure;
�
Never switch the equipment on when
the rotating accessory is touching the
work piece/surface. Only after the
maximum rotation speed is reached,
the rotation accessory should be
leaned against the surface;
�
When using the tool to sharpen,
sanding or to perform any other
type of rectification, always keep an
angle of 15° between the disc and the
surface. This procedure increases the
disc capacity and removal avoiding
unnecessary overloads;
�
Do not use water or lubricant while
sharpening;
Be particularly careful when using this
tool in corners or sharpen edges. Avoid
that the accessory loses or get stuck in
the work piece;
4.1 -ANGLE GRINDER'S START
AND STOP (FIG. G)
1. Hold the tool with both hands, one
hand over the handle (8) and the other
over the side handle (5);
2. Press the safety lever (9) and the
"ON/OFF" switch (6) simultaneously.
If the safety lever isn't pressed, the
"ON/OFF" switch keeps locked;
3. To switch the equipment off, release
the "ON/OFF" switch;
4.2 - ROTATION SHAFT LOCK
(FIG. H)
Never press the rotation shaft
locking button while the tool is
running. Otherwise, it may damage
the equipment;
1. Press the locking button to avoid
the shaft's rotation when replacing or
removing the accessories;
2. To release the rotation shaft, loose
the locking button;
28
5. MAINTENANCE
AND CLEANING
INSTRUCTIONS
Before inspection, maintenance and
cleaning works, turn the equipment off
and remove the battery.
This equipment doesn't need additional
lubrication or maintenance. However,
it
needs
a
proper
and a regular cleaning to operate
continuously with no issues.
CLEANING AND STORAGE
CLEANING
After
each
use
clean
components. Clean the machine with a
clean and damp cloth and blow it with
low pressure compressed air. A careful
handling protects the machine and
extends its lifespan.
This machine and its ventilation
openings must be always clean. Clean
it regularly or every time they get
obstructed.
STORAGE
Every time the machine isn't being
used, store it inside dry, clean and
corrosive steam free places away from
children's reach. Remove the battery
when storing the tool.
6. ENVIRONMENT
The packaging is made of recyclable
materials, which can be disposed on
local recycling points.
Never place power tools in
the domestic waste!
maintenance
According to the European
Directive
electrical
equipment waste and its transposition
into national law, power tools must be
collected separately and delivered to
the collection sites provided for this
purpose.
all
the
You can obtain information regarding
the disposal of the machine through
the person in charge for the recycling
in your city.
7. CUSTOMER
Phone: (+351) 256 248 826
E-mail: international@centrallobao.pt
Website: www.centrallobao.pt
SAFETY
2012/19
/EC
on
and
electronic
SERVICE
Publicidad
