Publicidad
Idiomas disponibles
Idiomas disponibles
TRANSPORTATION AND HANDLING
5 Store the air inlet grille.
!
C A U T I O N
•
When storing the air inlet grille in the air panel, ensure that the air inlet
grille is horizontal and the suspension wire tightly stretches. If the air
inlet grille is raised while tilted, it may not be stored properly. Also, if
the air inlet grille is tilted or the suspension wire is raised while it is
slack, the suspension wire may become entangled in the elevating
mechanism, making it impossible to move up and down.
•
Turn the wire holder until it clicks, and make sure that the L-shaped
rib on the air inlet grille and the knob on the wire holder are in contact.
If the wire holder is not attached properly, the air inlet grille may fall
and cause injury
7.2 MAINTENANCE AT BEGINNING AND END OF USE
At beginning of use
•
Remove obstacles around the air inlet grilles and the air
outlet of the indoor unit and outdoor unit.
•
Check that the air filter is not clogged with dust and dirt.
8 TRANSPORTATION AND HANDLING
1 Transport the air panel without unpacking as close to the
installation location.
2 Mount the air panel as soon as possible after unpacking.
3 When the air panel is placed on the floor after unpacking,
place the air panel on the packing as shown below to avoid
damaging the insulation material on the back of the air panel.
However, do not leave the air panel on the floor for long time.
It may cause air leakage due to scratch the seal packing.
In addition, if the air panel is placed with the surface
downward, the louver mechanism may be damaged due to
touch the louver to the floor, etc.
9 BEFORE INSTALLATION
Check to ensure that the following accessories are packed with the air panel. If any of these accessories are not packed in the
packing, please contact your contractor.
Long Screw (M6 Cross Screw)
9
PMML0568 rev.0 - 01/2021
Name
P-GP160NAP
P-GP-160KAP
4
Hook
-
Knob
At end of use
•
Clean the air filter, the air inlet grille and the air panel.
4 Do not move the louver by hand. If moved, the louver
mechanism will be damaged.
Packing
Quantity
P-GP160NAPU
4
For fixing air panel
2
For temporary hanging the air inlet grille
L-shaped
Rib
Purpose
Publicidad
