Kärcher BD 70/75 W Classic Bp Manual De Instrucciones página 14

Malfunction
The suction performance is
too low
The cleaning results are un-
satisfactory
The suction turbine runs at
an increased speed
The brushes do not rotate
The device vibrates during
cleaning
Description
Disc brush, white (soft)
Disc brush, natural colour (soft)
Disc brush, red (medium, standard) 4905-010.0
Disc brush, black (hard)
Pad drive board
Pad, white
Pad, red (medium soft)
Pad, green (medium hard)
Pad, black (hard)
Pad, brown (SPP)
Description
Roller brush, white
Roller brush, red
Roller brush, orange
Roller brush, green
Roller brush, black
Pad roller shaft
Microfiber roller
Description
Suction bar, 950 mm, curved
Suction bar, 1030 mm, curved
Suction bar, 1160 mm, curved
Suction lip set, natural rubber
PU suction lip set
Suction lip set, Linatex
14
Rectification
1. Shut down the device and drain the waste water.
2. Clean the seals between the waste water tank and the cover, check for leaks and replace if neces-
sary.
3. Check that the suction hose is correctly connected to the waste water tank.
4. Check the fluff filter for soiling and clean if necessary.
5. Clean the suction lips at the suction bar, turn over or replace if necessary.
6. Check that the cap on the waste water drain hose is closed.
7. Check the adjustment of the suction bar.
8. Check the suction hose for clogging and clean if necessary. The white marking on the hose must
lie at the retaining clip when the suction hose is re-inserted.
9. Check the suction hose for leaks and replace if necessary.
1. Reduce the driving speed.
2. Check the brushes for wear and replace if necessary.
3. Check the suitability of the brush type and detergent used.
1. Drain the waste water.
2. Clean the float.
3. Check the fluff filter and clean if necessary.
4. Check the suction hose for clogging and clean if necessary.
5. Check the suction bar for clogging and remove any clogging if necessary
1. Check if the brushes are blocked by a foreign body and remove the foreign body if necessary.
1. Use a softer brush.
Accessories BD variant
BD 70/75 BD 80/100
part no. part no.
4.905-011.0 4905-030.0
4905-012.0 4905-031.0
4.905-000.0 For use in all common cleaning tasks
4905-013.0 4905-032.0
4762-590.0 4762-447.0
– 6.371-331.0 For polishing floors
6.369-003.0 6371-147.0
6.369-002.0 6371-148.0
6.369-001.0 6371-169.0
2.639-290.0 2639-288.0
Accessories BR variant
BR 75/75 BR 85/100
part no. part no.
6.907-771.0 6907-772.0
4.035-605.0 4.035-606-0 For maintenance cleaning of heavily soiled floors.
6.907-730.0 6907-734.0
6.907-732.0 6907-735.0
6.907-732.0 6907-736.0
4762-627.0 4762-628.0
4114-007.0 4114-008.0
Accessories BD and BR variants
BD 70/75 W
Classic Bp
NA
Part no.
4.777-111.0 –

–
–
4.037-174.0 4.037-144.0 4.037-138.0 Standard
4.037-173.0 4.037-145.0 4.037-140.0 Oil-proof
4.037-175.0 4.181-011.0 4.181-006.0 Tear-proof
Description
For cleaning lightly soiled or sensitive floors
Made of natural fibres for cleaning and polishing
For heavy soiling and basic cleaning, only for non-sensitive surfaces
For cleaning with pads, with quick-change coupling and centre-lock
For cleaning all floors
For cleaning heavily soiled floors and for basic cleaning
For stubborn soiling and for basic cleaning
For protective film application on hard and elastic surfaces
Description
For polishing and maintenance cleaning of sensitive floors.
For scrubbing structural floors (safety tiles, etc.).
For basic cleaning of heavily soiled floors and for coating removal
(e.g. waxes, acrylates).
For holding roller pads.
For maintenance cleaning of smooth floors.
BD 70/75 + BD 80/100 +
BR 75/75 BR 85/100
part no. part no.
–
4.777-108.0 –
– 4.777-102.0 Standard
English
Description
For narrow passage widths
Standard