Publicidad
Idiomas disponibles
Idiomas disponibles
CASE 2: default address of the device (192.168.1.200) NOT belonging to the same router
network (e.g.: 192.168.0.1)
Interface A must be assigned a new "Static IP Address" in the same network as the
devices connected to interface A
ASSIGN A NEW STATIC IP ADDRESS TO INTERFACE A
The following procedure describes how to assign network settings to the device1456B that are compatible with
those of the devices connected to interface A.
1. Open the software ViP Manager version 2.13.0 or later (downloadable from the website pro.comelitgroup.com).
2. From Options [a] / Local connections [b] untick the DHCP enable box and assign an IP address to your
PC [c] (in the example: 192.168.1.2)* that belongs to the same network as the IP address of interface A
(default=192.168.1.200) and confirm [d].
* the last value must be within the range of 2 to 253 excluding: 200 (assigned to the gateway Art. 1456B)
and the values already assigned to other devices connected to the network.
f
3. Launch the system scan by pressing Scan System [e]
Art.1456B
t.
ONLY WITH COMELIT RED CABLE 2E7T000500
ONLY WITH COMELIT RED CABLE 2E7T000500
SETTABLE POE
FIXED POE
NON POE
A1
A2
A3
A4
...
...
ROUTER
192.168.0.1
Installer PC
b
INTERFACE A
STATIC IP ADDRESS
192.168.1.200 (default)
192.168.0.X
a
Assign to the PC an
IP address that is
compatible with the
c
network of the 1456B
(e.g.: 192.168.1.2) so that
the two devices are able
to communicate
d
19
Publicidad
