Olympia A 370 Manual De Instrucciones página 13

All manuals and user guides at all-guides.com
Clearing Foil Jams
The laminator is provided with a "Jam Release" function in order to clear foil
jams quickly.
1 If the foil jams, switch the equipment off and set the switch on the top,
right side of the unit to its "Jam Release" position.
2 Hold the laminator firmly and pull the foil together with the document to
be laminated out of the laminator's insertion slot.
3 Set the switch on the top, left side of the unit to its "Normal Operation"
position.
4 It will probably be necessary to then clean the unit several times as
described in the Section "Cleaning and Servicing".
5 If foil jams occur repeatedly or jammed foil cannot be removed from
the laminator, please contact our hotline.
Cleaning and Servicing
Deposits and residual adhesive on the transport rollers can influence the re-
sults of the laminating process. Therefore, the transport rollers must be
cleaned periodically after use:
To do this, insert a folded piece of paper in the insertion slot. Residual adhe-
sive is removed and taken up by the paper when ejected. Repeat the proc-
ess several times.
Disconnect the power plug before starting to clean the unit with a damp cloth.
If necessary, the housing can be cleaned using a cloth moistened with clean
water with a little mild soap applied. Never use any solvents or aggressive
cleaning agents.
Troubleshooting
Fault
 Red LED (Power) does not light up
 Unit does not respond
 Foil jam
Corrective measures
 Check that the power plug has
been properly connected to the
power socket.
 If the fault cannot be cleared, con-
tact our hotline.
 Check the foil pockets being used
are the correct size.
 Only use pouches of the size speci-
fied.
 Ensure that the pouch has been in-
serted correctly in the unit.
13