Publicidad
Idiomas disponibles
Idiomas disponibles
•
If the LED lights up red, please try again.
•
Please select, in which application (e.g. climate control and/or
security) you would like to use the device.
•
In the app, give the device a name and allocate it to a room.
Do not insert the battery compartment cover (C) yet.
•
6.2
Installation
The device must be mounted horizontally so that it can detected
position changes.
You can attach the device to the desired position with either
•
the supplied double-sided adhesive strips or
•
the supplied screws
.
6.2.1
Adhesive strip mounting
Make sure that the mounting surface is smooth, solid, non-dis-
turbed, free of dust, grease and solvents and not too cold to ensure
long-term adherence.
To mount the device with adhesive strips, please proceed as follows:
•
Insert the battery compartment cover (C) until it fully latches into
place.
•
Attach the double-sided adhesive strips to the back of the battery
compartment cover (C) (see figure 4).
•
Press the back of the device onto the desired position.
6.2.2
Screw mounting
When selecting the installation location, check for electrical wires
and power supply cables.
To mount the device using screws, please proceed as follows:
•
Use a pen to mark the positions of the two bore holes with a dis-
tance of 40 mm on the wall.
•
Position the battery compartment cover on the desired mount-
ing position.
Start-up
27
Publicidad
