HomeMatic IP HmIP-STV Manual De Instalacion Y Uso página 26

Start-up
6 Start-up
Do not install the cover until assembly and installation are com-
plete.
6.1 Pairing
Please read this entire section before starting the pairing procedure.
First set up your Homematic IP Access Point via the Homematic IP
app to enable operation of other Homematic IP devices within your
system. For further information, please refer to the operating manu-
al of the access point.
To integrate the device into your system and enable it to communicate
with other Homematic IP devices, you must first add the device to your
Homematic IP access point.
For pairing, proceed as follows:
• Open the Homematic IP app on your smart phone.
• Select the menu item "Add device".
Press the latch on the battery compartment cover (D) to open
•
the battery compartment (E) (see figure 2).
• Remove the insulation strip from the battery compartment.
• The pairing mode is active for 3 minutes.
You can manually start the pairing mode for another 3 minutes by
briefly pressing the system button (A) (see figure 3).
• Your device will automatically appear in the Homematic IP app.
• To confirm, enter the last four digits of the device number (SG-
TIN) in your app, or scan the QR code. The device number can be
found on the sticker supplied or attached to the device.
• Wait until pairing is completed.
If pairing was successful, the LED (A) lights up green. The device
•
is now ready for use.
26