Publicidad
Idiomas disponibles
Idiomas disponibles
Changing the batteries
The screw holes (B) in the battery compartment cover do not have
to be pre-drilled. You can simply screw the screws in through the
plastic.
If you have wooden walls, you can pre-drill the holes with a 1.5 mm
drill bit to make the screws easier to insert.
•
Fasten the battery compartment cover by screwing the screws
(see figure 5).
•
Place the device on the mounted battery compartment cover
until it fully latches into place.
7
Changing the batteries
If an empty battery is displayed via the app or the device (see „8.4 Error
codes and flashing sequences" on page 30), replace the used batter-
ies by two new LR03/micro/AAA batteries. You must observe the correct
battery polarity.
To replace the device batteries, please proceed as follows:
•
In the mounted condition, the device can be separated easily
from the battery compartment cover (C) by pressing the latch (D)
up(see figure 2).
•
Remove the used batteries.
•
Insert two new 1.5 V LR03/micro/AAA batteries into the battery
compartment (E), making sure that you insert them the right way
round (see figure 6).
•
Please pay attention to the flashing signals of the device LED
while inserting the batteries (see „8.4 Error codes and flashing
sequences" on page 30).
•
Replace the device on the mounted battery compartment cover
until it fully latches into place.
28
Publicidad
