Zizito FONTANA II Manual De Instrucciones página 22

EN
6.INSTALLATION IN VEHICLE
6.1.Seat installation: Place the child seat to the
rear seat in the vehicle, Let the bottom of the seat
against vehicle seat surface, and the front of the
seat touched vehicle seat backrest.(fig.26)
6.2.Then extend the vehicle belt longer enough,
Insert it from the slot at the front of the seat, then
through it into the slot at the another side.(fig.27).
6.3.Insert the buckle tongue(part no.12 page01)
into the vehicle buckle(part no.13),and hear a
"click".(fig.28).
6.4.nsert the diagonal belt into the slot at the rear
or C 8(part no.19 page 01).(fig.29).
6.5.Pull the diagonal belt at the top of the vehicle
buckle make the belt tight.(fig.30).
6.6.Then pull the diagonal belt at the top of the
seat as arrow indicate. As tight as you can.(fig.30).
6.7 Installation of child: Refer the(section 7)to fix
your child carefully to finish the installation. Finally
check the child seat is fix stable on the vehicle
seat. If you find any shake that you must tighten
the belt again until the child seat is tight enough.
IMPORTANT: Misuse the child car seat will
reduce the protect that the seat provide. check the
belt at the right position and is tight enough at all of
the position, and no twist is appeared.
22