Zizito FONTANA II Manual De Instrucciones página 24

EN
8.REMOVING AND REPLACING THE COVER
The fabric cover on this seat can be remove for washing, It just need release
the plastic clip and pull out at the fringe of the seat.(fig.36). After washing
you can assemble it to the seat again. The seat cover is a part of the child
seat, The child restraint must not be used without the cover. The seat cover
should not be replaced with any other than the one recommended by the
manufacturer, because the cover constitutes an integral part of the restraint
performance.
SUGGESTION: Do not wash the fabric frequently. It must assemble again
as original state after washing. To replace the cover, follow the steps of re-
moving the cover in reverse order.
9. WASHING AND MAINTENANCE
Check if there is any part has missed or broken, if this is the case do not use
the seat again.
9.1 Fabric:
Fabric can wash by the temperature less than 30'C. Then dry by nature
condition.
9.2 Belt and plastic:
Wash fabric with warm water and mild soap, do not use solvents or high-po-
tency soap:
Do not remove, move or change fabric and original fabric or any part of the
harness.
9.3 Buckle:
Always check that there is no food debris or other such matter in the harness
buckle. This may affect the correct function of the buckle please clean it by
warm water. You can hear a"click"when the buckle function is normal.
24