Power smart DB2418 Manual Del Usuario página 12

3. While holding the start switch button , pull the handle bar (P) toward you until it touches the handle .
The start button must be pressed in and held before pulling the handle. Once the snow thrower starts,
release the start button.
To stop, release the handle bar (P) and allow the handle bar to return to the OFF position.
NOTE: Unit will not operate if you pull the bar towards you first then press in the start button.
CHUTE DISCHARGE DIRECTION ADJUSTMENT
WARNING
Never direct the snow discharge chute at the operator, bystanders, vehicles, or nearby windows.
Discharged snow and foreign objects accidentally picked up by the Snow Thrower can cause
serious damage and severe bodily injury. Always point the discharge chute in the opposite
direction from potential hazards.
1. To adjust the discharge chute (H), rotate the handle on the chute control rod in the direction
that you wish to direct the snow stream.
2. To adjust the chute deflector (G), loosen both chute deflector knobs to raise or lower the
deflector to the desired height you wish to throw the snow. Tighten the knobs to secure the
deflector.
12