Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
The handle is not in
The bolts are not properly seated.
position.
The battery is not charged.
The switch is defective.
The snow thrower
Battery is too cold.
doesn't start.
The battery is not attached to the
motor.
Battery may require service or
replacement.
The motor is on, but
the impeller does not
The belt is damaged.
turn.
The snow thrower
leaves a thin layer of
The scraper is worn.
snow behind.
SOLUTION
Make sure the bolts are correctly installed through the
handle bars. Check to see if the hand knobs are tight.
Refer to Assembling the Handle section in this manual.
Charge the battery by following the procedures in the
battery and charger manual.
Have the switch replaced by an authorized service
center.
Remove battery from snow thrower. Place battery on
charger and allow to charge for 10 minutes. Remove
from charger and install in Snow thrower for use.
Check the connection between the motor connector and
the battery.
Call toll free helpline
Replace the belt
Inspect the scraper for wear or damage.Replace the
scraper.
15
Publicidad
