Power smart DB2418 Manual Del Usuario página 9

3. Use the knob (CC) to secure the connection. The knob (CC) should be inserted outside of the frame.
Tighten the knob just snug to the handle.
NOTICE: Do Not over tighten the knob. The knob tightens as it is pivoted when clamped. If the knob
is initially threaded too tight and then clamped, it will break. Only slight clamping pressure is required
to hold the handle in place.
Position upper frame (C) as shown (handle bar up) Align mount holes with holes on middle frame
4.
(B).
5. Repeat step 2. Same installation method. See Figure 5.
6. Repeat step 3. Same installation method. See Figure 6.
7. Use the screw and washer to install the battery pack fixation.
Locate the three cable clips(D) in the part bag. Secure the power cord to the frame of the unit by
8.
clipping them onto the frame at evenly spaced intervals.
9. Loosen the two knobs on the chute deflector (G). Lift the chute deflector (G) so that it locks securely
to the discharge chute (H).
10. Loosen the two knobs on the chute deflector (G). Set the chute deflector to the desired angle and
tighten the chute deflector knobs.
Note: Do not over tighten the chute deflector knobs.
9