Publicidad
Idiomas disponibles
Idiomas disponibles
A
Lower frame
B
Middle frame
C
Upper frame
D
Connect line
E
Upper chute crank
F
Lower chute crank
G
Chute deflector
H
Discharge chute
I
Main cover
J
Auger
ASSEMBLY AND ADJUSTMENTS
The following section describes steps necessary to prepare the snow thrower for use. If after reading this
section, you are unsure about how to perform any of the steps please call (800) 791-9458 Mon-Fri 9-5
EST for customer service. Failure to perform these steps properly can damage the snow thrower or
shorten its life.
Unpacking
Unpack the snow thrower and all its parts, and compare against the list below.
1. Manual*1pc
2. Battery&Charger*1pc
3. Discharge Chute Assembly*1pc
4. Discharge chute crank*1pc
5. Knobs*4pcs
6. Clips*3pcs
ASSEMBLY
1. Position the middle frame (B) with the arrow on the "UP" decal
pointing UP when viewed from rear. Align the middle frame mount
holes to the holes on the lower frame (A).
Note: If middle frame (B) is installed upside-down, the chute crank
rod eye-bolt will not line up when installing the chute crank rod.
2. Insert the screw (AA) with the metal washer (BB) into the aligned
holes on each side. The metal washer (BB) should be inserted outside
of the frame.
K
Rubber plate
L
Scraper
M
wheel
N
Switch housing
O
Battery holder
P
Handle bar
Q
Eye bolt with rubber grommet
R
Discharge chute base
S
Charger
T
Battery
8
Publicidad
