Publicidad
Idiomas disponibles
Idiomas disponibles
DISPLAY
DESCRIPTION
SYSTEM PRESSURE
P 3.2
Measured pressure of the system
WORK FREQUENCY
F 45
Immediate frequency of operation of the motor
ABSORBED CURRENT
A 6.5
Immediate current absorbed by the motor – ATTENTION: RMS value:
the reading of the electric current entering and exiting from the inverter, registered by normal
measuring instruments (eg. amperometric clamp), could be incorrect.
TEMPERATURE OF POWER MODULE
Tm 50
Temperature of the electronic power module of the inverter
VISUALISATION OF THE FIRMWARE VERSION (FW)
In order to visualise the FIRMWARE (FW) version of the INTERFACE (FWI) card and the POWER (FWP) card:
• Take the TISSEL-100 OUT OF SERVICE (OFF) by pressing the
• Press both the keys at the same time
SETTING THE PARAMETERS IN THE HIDDEN LISTS
In order to enter into the HIDDEN LISTS where there are the advanced parameters and if it were necessary to modify the factory
values of these same parameters proceed as follows.
• Take the TISSEL-100 OUT OF SERVICE (OFF) by pressing the
• Press both the keys at the same time
HIDDEN LISTS
BASIC LIST
BASIC
Parameters
ADVANCED LIST
ADV
Parameters
INSPECTION LIST
INSP
Parameters
TEST Mode
TEST
(accessible only in the OFF
mode)
28
| ENGLISH
key
key
+
+
These are BASIC PARAMETERS which have to be set depending on the
application.
These are the ADVANCED PARAMETERS which improve the functioning and which
require a detailed knowledge of the system.
These are the INSPECTION PARAMETERS which enable the user to inspect the
operational status of the system, visualising hours of work, number of starts,
history of the alarms, etc.
The TEST mode allows one to start and stop the pump manually (ON/OFF key)
and modify the frequency by 1 Hz at a time. It also allows one to control the
functional parameters of the motor and of the inverter.
ATTENTION: when functioning manually some of the automatic
controls are excluded and the operator must avoid any wrong
manoeuvres.
U.M.
bar
Hz
A
°C
Publicidad
