Publicidad
Idiomas disponibles
Idiomas disponibles
Turntable installation
Place emaple underneath
Gyratory Plate
Rotating axis
Before installation
Remove all packing material and accessories. Check
the oven for damage, such as a dented or broken door.
Do not install the oven if it is damaged.
Installation
1. Choose a level surface that has sufficient space for air
inlets and outlets.
30 cm.
20 cm.
Despejado
20 cm.
A minimum clearance of 20 cm is required between the
oven and adjacent walls.1. Leave a minimum clearance
of 30 cm above the oven.2. Do not remove the legs from
the bottom of the oven.
Power saving during standby mode
The energy saving function deactivates the display 60 seconds after any selection, ensuring minimum power
consumption during standby mode. To activate the display, select any button on the control panel or open the door.
Rotating aro
a. Never turn the turntable upside down, as it must be in
motion.
b. The turntable and turntable ring must always be used
for cooking.
c. All food and its containers should always be placed on
the turntable.
d. If the turntable or turntable ring is broken or cracked,
contact the nearest authorized service center.
Housing: remove the protective film from the housing
surface.
Do not remove the light brown mica cover attached to
the oven cavity to protect the magnetron.
3. Blocked air inlets and/or outlets can damage the
oven.
4. Place the oven as far away as possible from radios
and TV sets. Operation of the microwave oven may
cause interference in the reception of radio or TV
broadcasts.2. Plug the oven into a conventional
household outlet. Make sure that the voltage and
frequency is the same as the voltage and frequency
indicated on the label of the appliance.
WARNING: Do not install the oven over a grill or other
heat-producing appliance. If installed near or over a heat
source, the oven may be damaged and void the warranty.
Surfaces within reach may become hot during
operation.
English-6
Publicidad
