TRAPP TRF 50 Manual De Instrucciones página 43

www.trapp.com.br
Gasoline
Certify that there'-s oil in the crankcase and if the

level is correct. The factory engines use 20W50 oil.
Check for the presence of gasoline in the fuel tank.

Check the gasoline tank capacity and the amount of

crankcase oil on in the engine manual.
5
4
3
2
After refueling with gasoline and adding oil to the

crankcase, turn the power cut-off switch (1) on, open
the fuel valve (3), place the choke lever (4) and the
throttle lever (5) towards the rabbit direction.
Instructions Before Operating the Shredder
Checking:
Before operating the shredder check:
If there are tools or objects on the motor or on the

equipment, mainly inside the grain funnel or in the
green crop feeder.
If there is something obstructing the motor.

If the rotation direction is correct.

If the voltage of the power source is the same of that

of the shredder.
If all the equipment's screws are tightened.

Carefully pull the retractable (2) start rope until you

find some resistance, then pull it all the way through.
Repeat this procedure until the engine runs.

Release the rewind starter rope gently to avoid

damaging the engine's covers.
Allow the motor to heat up for some minutes.

Return the choke lever (4), when returning the choke

lever to the original position, if the engine does not
turn off, this indicates the engine is warmed up.
Activate the throttle lever and start working with the

maximum rotation.
In an emergency situation, in order to turn the

1
engine off turn the power cut-off switch (1) off.
Under normal conditions, to turn the engine off,
close the fuel valve (3) and let the engine turns off
due to lack of fuel in the carburetor, then, turn the
power cut-off switch (1) off.
Note: For further information on the operation, refer to
the motor manual.
If there are no people or object close to the belt

pulleys or in the direction of the material to be
shredded. Keep people and children in a radius of
30 m far from the equipment.
If the shredder cover is properly closed.

If the counter cutting blade is properly set and

tightened (page 50).
Note:
If the equipment is properly prepared,

start the motor, allow it to reach
maximum revolution and start working.
43