Descargar Imprimir esta página

TRAPP TRF 50 Manual De Instrucciones página 52

Trituradores forrajeros
Ocultar thumbs Ver también para TRF 50:

Publicidad

Idiomas disponibles

Idiomas disponibles

Periodic Maintenance Plan - Gasoline Motor
In the first five hours:
Substitute the crankcase oil.

After every five hours or daily:
Check the oil level.

Clean the vhole equipment.

Never start or leave the engine running in a confided

area or without proper ventilation. The gas from
the exhaust contains carbon monoxide which is
inodorous and lethal.
This shredder is provided with a four-cycle motor

and there is no oil added to the gasoline (for
shredders with motor).
Before operating, make sure the crankcase oil level

is right.
The motor leaves factory with neither oil nor fuel.

Never store the equipment with gasoline in the tank.

If required, keep the engine on until it turns off due
to the lack of fuel.
All oils must correspond to API SG-SL classification.
1. Equipment must be on a flat and level surface.
Remove the oil plug (2) using an appropriate
wrench, protection glasses and appropriate
gloves.
2. The oil will be more easily drained if it is already
warmed up and with the oil dipstick (1) open.
3. Collect used oil in proper container.
52
TRF 80G and TRF 300G
Important Recommendations
Oil Change for the Gasoline Motor
After every 25 hours:
Substitute the crankcase oil.

Air filter maintenance.

After every 50 hours:
Substitute the air filter.

After every 100 hours:
Substitute the spark plug.

Never service the shredder with the motor on.

For any kind of maintenance the spark plug must be

disconnected.
Warm the motor up before operating the shredder.

Caution: gasoline is highly flammable.

Turn off the motor before removing the fuel cap.

Do not add gasoline when the motor is running or

still hot.
Attention!
If motor is hot when changing oil, be careful to
remove oil container. Hot oil is released with
more pressure, and may cause burns.
www.trapp.com.br

Publicidad

loading